System Sets....Re: APPLY TO SELECTION doesn't in trigger
bob.miller at parker.com (10/28/08 12:40PM)
bob.miller at parker.com (10/28/08 12:40 PM)
...
Cc: 4D iNug Tech <4d_tech@...
<OF12FC6B13.5BF80692-ON852574F0.005B61D5-852574F0.005B8DF4@...
Wow, that's not in the docs. I won't go up against JPR anytime, but I
wonder if this advice is now one of those "urban legends" that were
once
true, but no more with more modern 4D versions...
- Bob Miller
Parker Hannifin Corp.
Jack des
Bouillons
<<jack.desbouillon
To
s@hobbsherder.com
4D iNug Tech
<4d_tech@...
cc
10/28/2008 11:51
Subject
AM
System Sets....Re: APPLY TO
SELECTION doesn't in trigger ...
Actually, I recall JPR suggesting that the system sets (LockedSet and
UserSet) be specifically cleared by the developer, first in a call
when a
new process is launched, and then after the set is used with the call
to
Use
Set...
Jack des Bouillons
Hobbs Herder Advertising
On 10/28/08 5:33 AM, "bob.miller@... <bob.miller@...
wrote:
READ WRITE([Table1])
CREATE EMPTY SET([Table1];"lockedset") ````This is a problem; LockSet
is
a
4D system set, no need to declare; you are actually
``
trouncing the system set
"PLEASE NOTE: The preceding information may be confidential or
privileged. It only should be used or disseminated for the purpose
of conducting business with Parker. If you are not an intended
recipient, please notify the sender by replying to this message and
then delete the information from your system. Thank you for your
cooperation."
Reply to this message
Summary created 10/28/08 at 1:33PM by Intellex Corporation
Comments welcome at: feedback@intellexcorp.com